Usage

Print bronzing pulp on the textile with 33T screen printing plate. Dry for two times at least after printing. Print more or make screen printing plate more thick if the obvious bulge is needed. Bake for five to ten minutes with about 150℃. Hot stamp after the bronzing pulp is completely dried. (Flat iron) temperature: 140-160℃, time: 15-25 seconds, pressure: more than 4kg/cm. (boiling hot) temperature: 180℃, time: one second, pressure: 4kg/cm^2. All these parameters belong to hot stamp foils with 16μm thickness. You can test hot stamp foils with 12μm thickness by lessening the parameters. You can adjust the parameters which is unstable according to the real situation.

Storage:

1、 Temperature: 5-20℃

2、 Vertical placement

3、 Humidity: 30-70%

4、 Avoid sunshine

General knowledge of hot stamping:

The reasons why foils are unable to hot stamp or strip when the hot stamping machine is in normal temperature are as follows:

1、 Hot stamping foils is not suitable for this substrate

2、 The temperature is not enough, you can test after rising temperature. Blue light reveals high temperature, and you can hot stamp after cool it down.

Attention:

Don’t wipe the surface with your hands or rubbing cloth after hot stamping. The effect of washing test is in its best after 24hours.